Mark Lubbock's Midge / MOLO Midge
Working from drawings previously published in "Model Engineer" I am going to machine a small 'diesel' aero engine
Several years ago, I modelled a model aero 'diesel' engine based on a set of drawings.
 |
 |
 |
 |
 |
 |
 |
 |
| Midge modelled in Creo | Mark Lubbock's Midge | Instructions Page1 | Instructions Page2 | Instructions Page3 | Instructions Page4 | Instructions Page5 | Instructions Page6 |
Below are the drawings I will be following, using the written article as guidance.
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
| Backplate | Carburettor | Compression screw | Contra Piston | Crankcase and Conrod | Crankshaft | Crankshaft | Cylinder Head | Cylinder | Gudgeon Pin | Needle Valve | Piston | Prop Nut | Spinner |
And so to make it...
